cla series heavy-duty clamp pneumatic & hydraulic cylinders

• pressure ratings: 150 psi pneumatic
• piston rods are 1/4" or 5/16" diameter on all cla cylinders dependent on bore size. they are super-finished stainless steel for maximum corrosion resistance.
• cylinder tubes are high-tensile aluminum alloy tubing, hard anodized finish.
• pistons are aluminum, secured by a roll pin.
• heads are accurately machined from aluminum bar stock.
• springs employed in the spring return models exert the following forces to return the piston and rod: the 3/4" bore models have a spring which exerts a 4 lbs. force as installed and a 9.4 lbs. force when compressed by stroke. the 1-1/8" bore models rate is 5-1/2 lbs. installed and 9 lbs. compressed. all spring forces are approximate.
• bronze bushing oil impregnated, for good lubrication and long life.
• cylinder assembly is held together with high-tensile steel tie rods. this is recognized by industry to be the best way to provide pre-stressed construction for rough service.
• rod seal is a self-adjusting modified u-cup.
• piston seals are self-adjusting modified u-cups.
• tube seals are flat gaskets, retained type, to prevent any possible extrusion.
• ports are 1/8" n.p.t.
• mounting may be accomplished by attaching the head, the cap, or side mounting by holes provided in the universal mount. tie rod holes tapped thru 8-32 or 10-32 for face mounting. pivot or clevis mount may be made by attaching brackets with cap screws provided (see accessories brochure). stud may be threaded into mounting plate, or secured by use of jam nut provided.